Fixing ink blobs on epson xp-830 prints

Black ink blobs dropped randomly on pages

My Epson XP-830 started dropping black ink globs on my prints, which would smudge and wreck photos. As I had recently installed $150 worth of ink, I didn’t want to just go out and get a new printer. I also liked the compact format of this printer, and wouldn’t just buy the same one, as this was starting to look like a doorstop after its 2nd set of cartridges. I wasn’t concerned about breaking the printer at this point, because I was ready to throw it out.

I managed to resolve the issue – I’ve decided to write about what I did, and perhaps some will find this article and I’ll save a few printers from an early trip to the landfill. I expect this will work for any Epson XP printer.

First, I ordered a print head cleaning kit from Amazon (kit, Amazon link). In hindsight, I don’t actually think this was an issue with my print heads, but I did a number of things all at once, so I don’t know exactly which step resolved my issue. I recommend watching their video before ordering the kit.

The first step was getting the print head out of its right-side dock. Go to the menu, click maintenance, and then click Ink Cartridge Replacement.

Click proceed.

At this point, the print head will have moved to its change cartridge position. Disconnect the power.

I used card stock and paper towels to clean all of the ink I saw in the areas identified by red arrows

At this point, I took out the cartridges, and I wrapped them in plastic wrap, following the guidance of the Print Head Hospital.

I did clean the heads, as instructed in the Print Head Hospital video, but I think what really made the difference for the black ink globs was the following: using cheap papertowels and cardstock, I cleaned up all the ink in the areas highlighted by arrows in the above image. I cleaned under the print head by cutting a ~1″ piece of cardstock, wrapping it with a paper towel, and running it underneath the assembly as shown at the 3:40 mark in the Print Head Hospital video, and repeated until the paper towel would come out clean.

I plugged the printer back in, re-installed the cartridges, ran the regular print head cleaning cycle 3 times (until the test page came out fine), and am now getting perfect prints.

Good luck – hope this helps.

5 thoughts on “Fixing ink blobs on epson xp-830 prints”

  1. Thank you for this article on Epson 830 print head cleaning. It is just what I needed to put some extra life in my printer and get rid of the black blobs on my output!

  2. Thank you – I appreciate your post – over a year and half later! Your suggestion to clean the sponge pad on the right-hand side with a paper towel made all the difference!

  3. Thank you from the bottom of my heart. Restored printer to function (only 3 tiny blobs remain) to tide me over until my Canon Pixma G2200 arrives. Thank you, thank you, thank YOU!

  4. Hi! Any chance you know exactly what that part is in your picture with the two arrows? I was cleaning the same area on the right hand side. Is it part of the overflow ink tank (resevoir? holder?). I actually took apart my printer to access the sponges so I could clean them. Worked well after but then I touched that area I mentioned and now my printer hates me.

    1. I’m not sure. My guess is in a cleaning cycle, the head just releases ink into the sponge, but I really don’t know. I didn’t take anything apart. I’m still using this printer, I’ve repeated this process at least one more time since I first wrote this article, and it is still going strong.

Leave a Reply to Barbara Cancel reply

Your email address will not be published. Required fields are marked *