Completed TV Remote

Building A TV Remote

After only a couple of uses, I decided the Alexa-powered TV remote I built earlier this year was not very useful. In my experience, there are few cases where voice control makes sense, and powering on my TV is not one of these cases. So I set out to build my own remote.

I built my own Arduino on a prototype board, using a circuit I had used before, the RRRRRRRRRRBBA really bare bones Arduino design. As I want it to last for a while on a set of batteries, I wired the buttons into an interrupt line. The micro-controller is programmed to be in sleep mode until a button is pressed, and then it wakes up, and sends the corresponding signal to the infrared LED. It will be interesting to see how long the batteries last – I’m hoping at least 6 months!

TV Remote Circuit
TV Remote Circuit

I laugh at the idea that my remote control runs at 16 MHz – 16x as fast as the C64 of my childhood.

TV Remote Circuit Board
TV Remote Circuit Board

I picked out a project box and some interesting buttons at my local electronics shop. The buttons are quite deep, which doesn’t lend itself to a thin remote. My remote has 4 controls: Power, Mute, Volume Up, Volume Down.

Completed TV Remote
Completed TV Remote

You can download the code here: ToshibaRemote.ino

Leave a Reply

Your email address will not be published.